ACQUTEK CORPORATION PM-7008 Card Type Virtual memory card Chip Set Unidentified Maximum Onboard Memory 256KB RAM or 512KB ROM I/O Options Watch dog timer connectors (2) Hard Drives supported None Floppy drives supported None Data Bus 8-bit ISA [Image] CONNECTIONS Function Label Function Label Watch dog timer reset CN1 Watch dog timer reset CN2 connector (out) connector (in) DIAGNOSTIC LED Function Label Watch dog timer status indicator L1 Note: Exact indicator status is unidentified. MEMORY CONFIGURATION The memory sockets (bank 0-3) on the PM-7008 accepts SRAM chips (62256) or EPROM chips(27512). The sockets may be filled in any order and a combination of SRAM and EPROM may be used. If ROM is used, the user must program the EPROM chips prior to installation. RAM/ROM SWITCH SETTINGS Setting Label 1-3 4-6 RAM enabled (bank 0) JP1 On Off ROM enabled (bank 0) JP1 Off On RAM enabled (bank 1) JP2 On Off ROM enabled (bank 1) JP2 Off On RAM enabled (bank 2) JP3 On Off ROM enabled (bank 2) JP3 Off On RAM enabled (bank 3) JP4 On Off ROM enabled (bank 3) JP4 Off On BIOS ADDRESS SELECTION Address DSW1/3 DSW1/4 D0000h Off Off D4000h On Off D8000h Off On DC000h On On BASE I/O ADDRESS SELECTION Setting DSW1/1 DSW1/2 200h Off Off 280h On Off 300h Off On Reserved On On